Product overview
ESD Gloves
PU Palm-Coated Carbon Fiber Gloves
| Material | Carbon-fiber knit with PU palm coating |
|---|---|
| Color | White; gray/gray-green presentation |
| Sizes | S, M, L |
| Packaging | 50 pairs/carton |
| Cleanliness designation | General |
| Test-report status | No product performance report specified |
| Listed resistance | Below 1.0 × 10¹¹; unit and test method not specified |
Select any required cut, chemical, cleanliness or ESD rating using an appropriate test report. Material and appearance alone do not establish a certified rating.
Glove sizing and application requirements can be customized after the required performance is agreed.
The palm-coated version places PU over a broad gripping area while retaining a knitted back. Carbon fiber is included in the fabric construction for applications that require evaluation of electrostatic behavior.
Use palm coverage where the whole hand supports the part
Broad palm contact is useful when the operator holds a panel, housing or component rather than touching only its edges. Check coating transfer and surface marking on the actual material. Keep gloves clean enough that collected debris does not become a new source of contamination.
Qualify electrical behavior in use
Conductive yarn alone does not prove that a gloved operator and the handled item are correctly grounded. Agree the electrical test method and acceptance limits for the complete working arrangement, including the glove's cleaning condition.
Compare this design with fingertip coating where greater palm breathability or a different contact pattern is needed. The choice should follow how the part is held, not only the visual similarity of the gloves. Inspect the elastic cuff and coating during issue and replace worn pairs before the grip becomes inconsistent.
Palm-width sizing guide
| S | Below 85 mm |
|---|---|
| M | 85–90 mm |
| L | 90–100 mm |
Measure across the palm and confirm finger length in a fitting trial. This is a fit guide; selected size availability must match the order.
Glove sizing and application requirements can be customized after the required performance is agreed.