Machine-made panel rounded outside corner
Cleanroom Aluminium Profiles
Cleanroom Coving and Corner Profiles
| Specification | Configuration options |
|---|---|
| Brand | shengtongJH |
| Profile types | Internal cove; rounded outside corner; single- and double-radius channels; corner covers |
| Cove radius option (mm) | 50 |
| Accessories | Clip base, backing angle, internal / external three-way corners, door end caps |
| Material options | 6063 aluminium; matching polymer connectors where required |
| Surface finish | Anodized or powder coated |
| Supply length (mm) | 3000; cut lengths to installation layout |
| Customization | Section, finish, cut length and connections to suit the installation |
Dimensions and configurations can be customized for your application.
Turn exposed room junctions into accessible, wipeable transitions with matched coves, corner covers and finishing pieces.
Finish the junction, not just the straight run
A rounded profile makes the transition between adjoining surfaces easier to wipe than a sharp, recessed corner. The difficult parts are often the ends: where a wall cove reaches a door, turns into a ceiling corner or meets another cove. Matching closures help those junctions remain continuous rather than becoming a collection of open cuts.
The range includes internal coves, single- and double-radius channels, rounded outside-corner sections and broad external corner covers. Machine-made and handmade panel corner sections have different engagement geometry; select the section that matches the actual panel edge rather than relying on a similar appearance.
Concealed support
A clip base or backing angle holds the finished cover in position. It should follow the wall accurately so the facing does not rock or leave a variable gap. Fix the support to an adequate substrate, then seal the exposed edges using a compatible material.
Three-way intersections
Internal and external corner pieces close the meeting of three surfaces. Door end caps terminate short runs without leaving an open profile mouth. Order these pieces with the straight lengths so the installer does not have to improvise closures from offcuts.
Choose for cleaning and traffic
Specify the cleaning method before choosing a finish. A powder-coated face can coordinate with the wall colour, while anodized aluminium has a different surface character. Neither finish should be assumed compatible with every concentrated cleaning chemical.
At trolley routes, consider the likelihood of impact and keep the corner cover supported. A cove makes cleaning easier, but it does not replace wall protection or compensate for a moving joint. Inspect the perimeter after installation, especially where floors or panels change direction.
Cove geometry, cover profiles, corner closures and lengths can be customized for the room junctions and daily cleaning process.